ZyXEL Communications MSC1000G Series, User Manual

Page: 293 / 1168

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
293
9.26 The H.248 Port Setup Line Card Screen
Use this screen to see and edit the current VoIP configuration of each port on a H.248 VoIP line
card. Click a line card’s
ID number in the Port > VoIP H248 screen. The following screen displays.
Figure 188
The Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
The following table describes the labels in this screen.
Table 133
Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
LABEL DESCRIPTION
UP Click this to return to the Port > VoIP H248 screen.
Copy Use this to assign the selected port’s settings to other ports.
1. Click Copy . The following pop-up screen displays.
Figure 189
Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All to select every
port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window without saving any
changes.
Apply Click this to save your changes to the MSC’s volatile memory. The MSC loses these changes if
it is turned off or loses power, so use the
Config Save link on the navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click this to begin configuring the fields again.