ZyXEL Communications MSC1000G Series, User Manual

Page: 240 / 1168

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
240
9.8.9 VDSL PVLAN Setup
Click Port > VDSL in the navigation panel to open the VDSL Port Setup screen. Select a VDSL
line card ID, a port index number and click Setup (next to PVLAN ) to open the following screen.
(Not all VDSL line cards support PVLAN.) Use this screen to configure Protocol VLAN (PVLAN)
settings for the VDSL port. PVLAN adds a VLAN ID and IEEE 802.1p priority to a specific protocol’s
untagged traffic.
Figure 148
VDSL PVLAN Setup
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
The table in the bottom half of the screen lists the VLANs that the port is a member of.
Modify Click Modify to display the selected VLAN membership entry’s settings in the fields above
so you can edit them.
Delete Click Delete to remove the selected VLAN membership entry.
Index This is the number of the VLAN membership entry.
VID This field displays the number of a VLAN (VLAN ID) of which this port is a member.
Registration This field displays “fixed” to indicate that the port is a member of the specified VLAN.
Tag This field displays “V” if the line card is to tag all frames that are transmitted out on this
port with this VLAN group ID. It displays “-” if the line card does not tag all frames that
are transmitted out on this port with this VLAN group ID.
Select Select the radio button of a VLAN membership entry and then use the Modify button or
the Delete button.
Table 105
VDSL Port Setup: VLAN Setup (continued)
LABEL DESCRIPTION