Chapter 49 Configure Clone
MGS3520 Series User’s Guide
391
Figure 255
Management > Configure Clone
The following table describes the labels in this screen.
Table 196
Management > Configure Clone
LABEL
DESCRIPTION
Source/
Destination
Port
Enter the source port under the
Source
label. This port’s attributes are copied.
Enter the destination port or ports under the
Destination
label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
•
2, 4, 6
indicates that ports 2, 4 and 6 are the destination ports.
•
2-6
indicates that ports 2 through 6 are the destination ports.
Basic Setting
Select which port settings (you configured in the
Basic Setting
menus) should be copied to
the destination port(s).
