Chapter 42 Access Control
MGS3520 Series User’s Guide
356
Figure 226
Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 178
Management > Access Control > SNMP
LABEL
DESCRIPTION
General Setting
Use this section to specify the SNMP version and community (password) values.
Version
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (
v2c
), SNMP version 3 (
v3
) or
both (
v3v2c
).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community
Enter the
Get Community
string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The
Get Community
string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Set Community
Enter the
Set Community
, which is the password for incoming Set- requests from the
management station.
The
Set Community
string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Trap Community
Enter the
Trap Community
string, which is the password sent with each trap to the
SNMP manager.
The
Trap Community
string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Trap Destination
Use this section to configure where to send SNMP traps from the Switch.
