ZyXEL Communications MGS-3712, User Manual

Page: 174 / 308

Chapter 22 Authentication & Accounting
MGS-3712/MGS-3012F User’s Guide
174
22.2.2 Server Setup
Use this screen to configure your server settings. See Section 22.1.2 on page 172
for more information on servers. Click on the Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
Delete Check this box if you want to remove an existing RADIUS server entry from the
Switch. This entry is deleted when you click Apply .
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Accounting
Server
Use this section to configure your RADIUS accounting server settings.
Timeout Specify the amount of time in seconds that the Switch waits for an accounting
request response from the RADIUS accounting server.
Index This is a read-only number representing a RADIUS accounting server entry.
IP Address Enter the IP address of an external RADIUS accounting server in dotted decimal
notation.
UDP Port The default port of a RADIUS server for accounting is 1813 . You need not change
this value unless your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external RADIUS accounting server and the Switch. This key is not
sent over the network. This key must be the same on the external RADIUS
accounting server and the Switch.
Delete Check this box if you want to remove an existing RADIUS accounting server entry
from the Switch. This entry is deleted when you click Apply .
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 57 Advanced Application > Auth and Acct > RADIUS Server Setup (continued)
LABEL DESCRIPTION