Chapter 48 Configure Clone
XMG1930 Series User’s Guide
361
Figure 260
Management > Configure Clone
The following table describes the labels in this screen.
Table 189 Management > Configure Clone
LABEL
DESCRIPTION
Source/
Destination
Port
Enter the source port under the
Source
label. This port’s attributes are copied.
Enter the destination port or ports under the
Destination
label. These are the ports which are going
to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
2, 4, 6
indicates that ports 2, 4 and 6 are the destination ports.
2–6
indicates that ports 2 through 6 are the destination ports.
*
Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Basic Setting
Select which port settings (you configured in the
Basic Setting
menus) should be copied to the
destination ports.
Advanced
Application
Select which port settings (you configured in the
Advanced Application
menus) should be copied
to the destination ports.
