Chapter 21 Classifier
MES3500 Series User’s Guide
171
21.3 Viewing and Editing Classifier Configuration
To view a summary of the classifier configuration, scroll down to the summary table at the bottom
of the
Classifier
screen. To change the settings of a rule, click a number in the
Index
field.
Note: When two rules conflict with each other, a higher layer rule has priority over a lower
layer rule.
Figure 94
Advanced Application > Classifier: Summary Table
The following table describes the labels in this screen.
Socket
Number
Note: You must select either
UDP
or
TCP
in the
IP Protocol
field before you configure the socket
numbers.
Select
Any
to apply the rule to all TCP/UDP protocol port numbers.
Select
Single
and enter a TCP/UDP protocol port number.
Select
Range
and choose a pre-defined socket port range profile.
Destination
IP
Address
Select
Prefix
to enter a destination IP address and specify the address prefix by entering the
number of ones in the subnet mask. Otherwise, select
Range
and choose a predefined
destination IP address range profile.
Socket
Number
Note: You must select either
UDP
or
TCP
in the
IP Protocol
field before you configure the socket
numbers.
Select
Any
to apply the rule to all TCP/UDP protocol port numbers.
Select
Single
and enter a TCP/UDP protocol port number.
Select
Range
and choose a pre-defined socket port range profile.
Add
Click
Add
to insert the entry in the summary table below and save your changes to the Switch’s
run-time memory. The Switch loses these changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Clear
Click
Clear
to set the above fields back to the factory defaults.
Table 59
Advanced Application > Classifier (continued)
LABEL
DESCRIPTION
Table 60
Classifier: Summary Table
LABEL
DESCRIPTION
Rule
Usage
This field displays how many rules have been configured on the Switch.
Index
This field displays the index number of the rule. Click an index number to edit the rule.
Summary of Contents for MES3500 Series
