ZyXEL Communications MES-2110, User Manual

Page: 58 / 184

Chapter 6 Configuration
MES-2110 User’s Guide
58
InBadOctets This field shows the number of bad octet frames received.
InUndersize This field shows the number of frames received that were too short
(shorter than 64 octets).
InFragments This field shows the number of frames received that were too short
(shorter than 64 octets) and were received with with Cyclical
Redundancy Check (CRC) errors.
InJabber This field shows the number of frames received with a length that
exceeds the maximum octet size and were received with CRC errors.
InOversize This field shows the number of frames received with a length that
was out of range.
TX
The following fields show detailed information about frames transmitted.
OutUnicasts
This field shows the number of good unicast frames transmitted.
OutBroadcasts This field shows the number of good broadcast frames transmitted.
Late This is the number of times a late collision is detected, that is, after
512 bits of the frames have already been transmitted.
Excessive This is a count of frames for which transmission failed due to
excessive collisions. Excessive collision is defined as the number of
maximum collisions before the retransmission count is reset.
Multiple This is a count of successfully transmitted frames for which
transmission was inhibited by more than one collision.
Single This is a count of successfully transmitted frames for which
transmission is inhibited by exactly one collision.
Deferred This is a count of frames for which transmission delayed due to busy
traffic. The deferred frames are waiting to be transmitted from the
Switch buffer. This counter only works for the half-duplex mode.
RX+TX
64 Octets
This field shows the number of frames (including bad frames)
received that were 64 octets in length.
65to127 Octets This field shows the number of frames (including bad frames)
received that were between 65 and 127 octets in length.
128to255 Octets This field shows the number of frames (including bad frames)
received that were between 128 and 255 octets in length.
256to511 Octets This field shows the number of frames (including bad frames)
received that were between 256 and 511 octets in length.
512to1023 Octets This field shows the number of frames (including bad frames)
received that were between 512 and 1023 octets in length.
1024toMax Octets This field shows the number of frames (including bad frames)
received that were between 1024 and the maximum octets in length.
Table 11 Configuration > Rmon Status (continued)
LABEL DESCRIPTION