Chapter 3 The Setup Screens
User’s Guide
36
3.4.1 Pre-Defined NTP Time Servers List
The WiMAX Modem uses a pre-defined list of NTP time servers if you do not
specify a time server or it cannot synchronize with the time server you specified.
It can use this list regardless of the time protocol you select.
When the WiMAX Modem uses the list, it randomly selects one server and tries to
synchronize with it. If the synchronization fails, then it goes through the rest of
the list in order until either it is successful or all the pre-defined NTP time servers
have been tried.
Get from Time Server (
從時間伺服器取得
)
Select this if you want to use a time server to update the current
date and time in the WiMAX Modem.
Time Protocol (
時間
通訊協定
)
Select the time service protocol that your time server
uses.Check with your ISP or network administrator, or use trial-
and-error to find a protocol that works.
Daytime (RFC 867) - This format is day/month/year/time
zone.
Time (RFC 868) - This format displays a 4-byte integer giving
the total number of seconds since 1970/1/1 at 0:0:0.
NTP (RFC 1305) - This format is similar to Time (RFC 868).
Time Server
Address (
時間伺服器
位址
)
Enter the IP address or URL of your time server. Check with your
ISP or network administrator if you are unsure of this
information.
Time Zone Setup (
時區設定
)
Time Zone (
時區
)
Select the time zone at your location.
Daylight Savings (
日光
節約
)
Select this if your location uses daylight savings time. Daylight
savings is a period from late spring to early fall when many
places set their clocks ahead of normal local time by one hour to
give more daytime light in the evening.
Start Date (
開始時間
)
Enter which hour on which day of which week of which month
daylight-savings time starts.
End Date (
結束時間
) Enter which hour on the which day of which week of which
month daylight-savings time ends.
Apply (
套用
)
Click to save your changes.
Reset (
重設
)
Click to restore your previously saved settings.
Table 7
SETUP
( 設定
) > Time Setting
( 時間設定
)
LABEL
DESCRIPTION
Table 8
Pre-defined NTP Time Servers
ntp1.cs.wisc.edu
ntp1.gbg.netnod.se
ntp2.cs.wisc.edu
tock.usno.navy.mil
ntp3.cs.wisc.edu
Summary of Contents for MAX-207HW2
