Chapter 10 Routing
Nebula Mobile Router User’s Guide
185
Figure 116
Network Setting > Routing > Static Route
The following table describes the labels in this screen.
10.2.1 Add or Edit Static Route
Use this screen to add or edit a static route. Click
Add New Static Route
in the
Static
Route
screen, the
following screen appears. Configure the required information for a static route.
Note: The
Gateway IP Address
must be within the range of the selected interface in
Use
Interface
.
Table 63 Network Setting > Routing > Static Route
LABEL
DESCRIPTION
Add New Static
Route
Click this to set up a new static route on the Zyxel Device.
#
This is the number of an individual static route.
Status
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Name
This is the name of the static route.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is always based
on network number.
Subnet Mask/
Prefix Length
This parameter specifies the IP network subnet mask of the final destination.
Gateway
This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Interface
This is the WAN interface through which the traffic is routed.
Modify
Click the
Edit
icon to go to the screen where you can set up a static route on the Zyxel Device.
Click the
Delete
icon to remove a static route from the Zyxel Device.
Summary of Contents for LTE3301-PLUS
