Chapter 6 WAN Network
LTE3202-M430 User’s Guide
40
Figure 23
LTE3202-M430 in Router Mode
•
Bridge Mode:
Select this mode if you already have a router in your network, and you don’t want to
reconfigure your network. If you don’t have a router, you’ll need multiple IP addresses from your ISP
for your clients.
Use this screen to change the LTE3202-M430’s operating mode. Click
Configuration > WAN network >
Operation Mode
to open the following screen.
Figure 24
Configuration > WAN network > Operation Mode
6.8 The Antenna Selection Screen
Click
Configuration > WAN network > Antenna Selection
to open the following screen.
The LTE3202-M430 has two internal antennas, you can also install two external antennas to improve your
wireless WAN signal strength. The LTE3202-M430 uses the internal antennas by default. If you installed
external antennas, select
External
for the LTE3202-M430 to use these to detect the WAN network. Click
Apply
to save your settings, otherwise select
Cancel
.
Figure 25
Configuration > WAN network > Antenna Selection
Summary of Contents for LTE3202-M430
Page 8: ...8 PART I User s Guide...
Page 21: ...21 PART II Technical Reference...