ZyXEL Communications LTE3202-M430, User Manual, Page: 37 / 117

Chapter 6 WAN Network
LTE3202-M430 User’s Guide
37
The following table describes the labels in this screen.
6.5 The Network Selection Screen
This screen allows you to view available Public Land Mobile Networks (PLMNs) and select your preferred
network when the LTE3202-M430 is outside the geographical coverage area of the network to which
you are registered and roaming is enabled.
Click Configuration > WAN network > Network Selection . The screen appears as shown next.
Figure 21 Configuration > WAN network > Network Selection
Table 15 Configuration > WAN network > APN Configuration
LABEL DESCRIPTION
APN Profile Select Auto to reload the default profile. Otherwise, select Manual to configure a connection
profile.
APN This field displays the Access Point Name (APN) in the profile.
Enter the Access Point Name (APN) provided by your service provider. Connections with
different APNs may provide different services (such as Internet access or MMS (Multi-Media
Messaging Service)) and charging method.
You can enter up to 30 printable ASCII characters. Spaces are allowed.
Username This field displays the user name in the profile.
Type the user name (of up to 31 printable ASCII characters) given to you by your service
provider.
Password This field displays the password in the profile.
Type the password (of up to 31 printable ASCII characters) associated with the user name
above.
Authentication The LTE3202-M430 supports PAP (Password Authentication Protocol) and CHAP (Challenge
Handshake Authentication Protocol). CHAP is more secure than PAP ; however, PAP is readily
available on more platforms. Select an authentication protocol used by the service provider.
Otherwise, select Auto to have the LTE3202-M430 accept this automatically. Select None , to
accept neither.
PDP type • Select Default to use the ISP’s default settings.
• Select IP if you want the LTE3202-M430 to run IPv4 only.
• Select IPv4v6 to allow the LTE3202-M430 to run IPv4 and IPv6 at the same time.
• Select IPv6 if you want the LTE3202-M430 to run IPv6 only.
Apply Click Apply to save your changes back to the LTE3202-M430.
Reset Click Reset to reload the previous configuration for this screen.