ZyXEL Communications IES-1248-71, User Manual

Page: 406 / 464

Chapter 56 Virtual Channel Management
IES-1248-71/73 User’s Guide
406
The following example has the device remove a 2684 routed mode traffic gateway entry for IP
address 192.168.10.102.
56.7.5 RPVC Set Command
Syntax:
ras> adsl rpvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<ip>/<netmask> <gateway ip>
where
This command adds a PVC to handle 2684 routed mode traffic.
"
You must use the
rpvc gateway set
command to configure the gateway’s
settings before you use the
rpvc set
command.
Figure 278 RPVC Gateway Delete Command Example
ras> adsl rpvc gateway delete 192.168.10.102
<portlist> =
The port(s) of the RPVC.
You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.
DS vcprofile =
Assign a VC profile to use for this channel’s downstream traffic
shaping.
[,US
vcprofile]> =
Assign a VC profile to use for policing this channel’s upstream
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
<ip> =
The subscriber’s CPE WAN IP address in dotted decimal
notation.
/<netmask> =
The bit number of the subnet mask of the subscriber’s IP
address. To find the bit number, convert the subnet mask to
binary and add all of the 1’s together. Take “255.255.255.0” for
example. 255 converts to eight 1’s in binary. There are three
255’s, so add three eights together and you get the bit number
(24).
Make sure that the routed PVC’s subnet does not include the
IES-1248’s IP address.
<gateway ip> =
The IP address of the gateway to which you want to send the
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.