ZyXEL Communications IES-1248-71, User Manual

Page: 330 / 464

Chapter 49 MAC Commands
IES-1248-71/73 User’s Guide
330
49.2.2 MAC Filter Enable Command
Syntax:
ras> switch mac filter enable [portlist]
where
This command turns on the MAC filtering feature on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
The following example turns on the MAC filtering feature on ADSL port 5.
49.2.3 MAC Filter Disable Command
Syntax:
ras> switch mac filter disable [portlist]
where
This command turns off the MAC filtering feature on the specified ADSL port(s) or on all
ADSL ports if no port is specified.
The following example turns off the MAC filtering feature on ADSL port 5.
49.2.4 MAC Filter Mode Command
Syntax:
ras> switch mac filter mode <port> <accept|deny>
where
This command sets whether the IES-1248 allows or blocks access for the MAC addresses you
specify.
[portlist] =
You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 173 MAC Filter Enable Command Example
ras> switch mac filter enable 5
[portlist] =
You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Figure 174 MAC Filter Disable Command Example
ras> switch mac filter disable 5
<accept|deny> =
accept = Only allow frames from MAC addresses that you
specify and block frames from other MAC addresses.
deny = Block frames from MAC addresses that you specify and
allow frames from other MAC addresses.