ZyXEL Communications IES-1248-71, User Manual

Page: 300 / 464

Chapter 45 Command Examples
IES-1248-71/73 User’s Guide
300
45.3.2 Log Clear Command
Syntax:
ras> sys log clear
This command clears the system error log.
"
If you clear a log (using the log clear command), you cannot view it again.
45.3.3 Info Show Command
Syntax:
ras> sys info show
This command shows general system settings, the BIN (firmware) version, system uptime and
bootbase version.
THERMO OVER
TEMPERATURE: dev:<id>
threshold:<threshold>
(degree C)
value:<temp>(degree
C)! WARN
The temperature was too high at one of the temperature sensors.
<id> -
0: sensor near the ADSL chipset
1: sensor near the CPU
2: thermal sensor chip
<threshold> - temperature limit
<temp> - temperature when the entry was logged
THERMO OVER
TEMPERATURE released:
dev:<id>
threshold:<threshold>
(degree C)
value:<temp>(degree
C)! INFO
The temperature at one of the temperature sensors has come back to
normal.
<id> -
0: sensor near the ADSL chipset
1: sensor near the CPU
2: thermal sensor chip
<threshold> - temperature limit
<temp> - temperature when the entry was logged
THERMO OVER VOLTAGE:
dev: <id> limit:
<threshold> value:
<voltage>! WARN
The voltage at one of the voltage sensors went above the accepted
operating range.
<id> 1=1.0v, 2=1.8v, 3=3.3v, 4=24v
<threshold> - voltage limit
<voltage> - voltage of the DC power when logged
THERMO OVER VOLTAGE
released:
nominal:<nominal>(mV)
value:<voltage> (mV)! INFO
The device’s voltage is back inside the accepted operating range.
<nominal> - nominal voltage of the DC power
<voltage> - voltage of the DC power when logged
Table 94 Log Messages (continued)
LOG MESSAGE TYPE DESCRIPTION