ZyXEL Communications GS2200 Series, User Manual

Page: 250 / 320

Chapter 34 Maintenance
GS2200 Series User’s Guide
250
34.2.1 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1
In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all
Switch configuration information you configured and return to the factory defaults.
2
Click OK to reset all Switch configurations to the factory defaults.
Figure 166
Load Factory Default: Start
3
In the web configurator, click the Save button in the top of the screen to make the changes take
effect. If you want to access the Switch web configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address
(192.168.1.1).
34.2.2 Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on the
Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
Restore
Configuration Click Click Here to go to the Restore Configuration screen.
Backup
Configuration Click Click Here to go to the Backup Configuration screen.
Load Factory
Default Click Click Here to reset the configuration to the factory default settings.
Save
Configuration Click Config 1 to save the current configuration settings to Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Reboot
System Click Config 1 to reboot the system and load Configuration 1 on the Switch.
Click Config 2 to reboot the system and load Configuration 2 on the Switch.
Note: Make sure to click the Save button in any screen to save your settings to the current
configuration on the Switch.
Table 102
Management > Maintenance (continued)
LABEL DESCRIPTION