ZyXEL Communications GS2200 Series, User Manual

Page: 231 / 320

GS2200 Series User’s Guide
231
C
H A P T E R
3 0
Static Route
30.1 Overview
This chapter shows you how to configure static routes.
The Switch uses IP for communication with management computers, for example using HTTP,
Telnet, SSH, or SNMP. Use IP static routes to have the Switch respond to remote management
stations that are not reachable through the default gateway. The Switch can also use static routes
to send data to a server or device that is not reachable through the default gateway, for example
when sending SNMP traps or using ping to test IP connectivity.
This figure shows a Telnet session coming in from network N1. The Switch sends reply traffic to
default gateway R1 which routes it back to the manager’s computer. The Switch needs a static
route to tell it to use router R2 to send traffic to an SNMP trap server on network N2.
Figure 151
Static Routing Overview
30.1.1 What You Can Do
Use the Static Routing screen ( Section 30.2 on page 232 ) to activate/deactivate this static route.
R1
R2
N1
N2
SNMP
Telnet