ZyXEL Communications GS2200-24P Series, User Manual, Page: 285 / 360

Chapter 32 Access Control
GS2200-24/24P User’s Guide
285
The following table describes the labels in this screen.
Table 90 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password)
values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch
must match the version on the SNMP manager. Choose SNMP version
2c (v2c), SNMP version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Get Community Enter the Get Community string, which is the password for the
incoming Get- and GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using
SNMP version 2c or lower.
Set Community Enter the Set Community, which is the password for incoming Set-
requests from the management station.
The Set Community string is only used by SNMP managers using
SNMP version 2c or lower.
Trap
Community Enter the Trap Community string, which is the password sent with
each trap to the SNMP manager.
The Trap Community string is only used by SNMP managers using
SNMP version 2c or lower.
Trap
Destination Use this section to configure where to send SNMP traps from the Switch.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps
to.
Port Enter the port number upon which the manager listens for SNMP traps.
Username Enter the username to be sent to the SNMP manager along with the
SNMP v3 trap.
Note: This username must match an existing account on the Switch
(configured in Management > Access Control > Logins
screen).
User
Information Use this section to configure users for authentication with managers
using SNMP v3.
Note: Use the username and password of the login accounts you
specify in this section to create accounts on the SNMP v3
manager.
Index This is a read-only number identifying a login account on the Switch.
Username This field displays the username of a login account on the Switch.