ZyXEL Communications GS2200-24P Series, User Manual, Page: 234 / 360

Chapter 25 IP Source Guard
GS2200-24/24P User’s Guide
234
25.7 ARP Inspection VLAN Status
Use this screen to look at various statistics about ARP packets in each VLAN. To
open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > VLAN Status.
Figure 122 ARP Inspection VLAN Status
The following table describes the labels in this screen.
Cancel Click this to clear the Delete check boxes above.
Change Pages Click Previous or Next to show the previous/next screen if all status
information cannot be seen in one screen.
Table 71 ARP Inspection Status (continued)
LABEL DESCRIPTION
Table 72 ARP Inspection VLAN Status
LABEL DESCRIPTION
Show VLAN range Use this section to specify the VLANs you want to look at in the
section below.
Enabled VLAN Select this to look at all the VLANs on which ARP inspection is enabled
in the section below.
Selected VLAN Select this to look at all the VLANs in a specific range in the section
below. Then, enter the lowest VLAN ID (Start VID) and the highest
VLAN ID (End VID) you want to look at.
Apply Click this to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified
above.
Received This field displays the total number of ARP packets received from the
VLAN since the Switch last restarted.
Request This field displays the total number of ARP Request packets received
from the VLAN since the Switch last restarted.