Chapter 35 Diagnostic
GS1350 Series User’s Guide
293
The following table describes the labels in this screen.
Table 145 Management > Diagnostic
LABEL
DESCRIPTION
Ping Test
IPv4
Select this option if you want to ping an IPv4 address, and select
vlan
to specify the ID
number of the VLAN to which the Switch is to send ping requests. Otherwise, select
–
to send
ping requests to all VLANs on the Switch.
IPv6
Select this option if you want to ping an IPv6 address. You can also select
vlan
and specify
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select
–
to
send ping requests to all VLANs on the Switch.
IP Address/Host
Name
Type the IP address or host name of a device that you want to ping in order to test a
connection.
Click
Ping
to have the Switch ping the IP address.
Count
Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Trace Route Test
IPv4
Select this option if you want to trace the route packets take to a device with an IPv4
address, and select
vlan
to specify the ID number of the VLAN on which the Switch traces
the path. Otherwise, select
–
to trace the path on any VLAN.
Note: The device to which you want to run a traceroute must belong to the VLAN
you specify here.
IPv6
Select this option if you want to trace the route packets take to a device with an IPv6
address.
IP Address/Host
Name
Enter the IP address or host name of a device to which you want to perform a traceroute.
Click
Trace Route
to have the Switch perform the traceroute function. This determines the
path a packet takes to the specified device.
TTL
Enter the Time To Live (TTL) value for the ICMP Echo Request packets. This is to set the
maximum number of the hops (routers) a packet can travel through. Each router along the
path will decrement the TTL value by one and forward the packets. When the TTL value
becomes zero and the destination is not found, the router drops the packets and informs the
sender.
Wait Time
Specify how many seconds the Switch waits for a response to a probe before running
another traceroute.
Queries
Specify how many times the Switch performs the traceroute function.
Ethernet Port Test
Enter a port number and click
Port Test
to perform an internal loopback test.
Port
This is the number of the physical Ethernet port on the Switch.
Cable Diagnostics
Enter a port number and click
Diagnose
to perform a physical wire-pair test of the Ethernet
connections on the specified ports. The following fields display when you diagnose a port.
Note: This feature is limited to within 100 meters only.
Port
This is the number of the physical Ethernet port on the Switch.
Channel
An Ethernet cable usually has 4 pairs of wires. A 10BASE-T or 100BASE-TX port only use and test
2 pairs, while a 1000BASE-T port requires all 4 pairs.
This displays the descriptive name of the wire-pair in the cable.
