ZyXEL Communications GS-4012F, User Manual

Page: 250 / 306

GS-4012F User’s Guide
Chapter 40 Command Examples 249
Figure 147 show ip Command Example
40.2.4 show logging
Note: This command is not available in User mode.
Syntax:
show logging
This command displays the system logs. The following figure shows an example.
Figure 148 show logging Command Example
Note: If you clear a log (by entering
y
at the
Clear Error Log (y/n):
prompt), you
cannot view it again.
40.2.5 show interface
Syntax:
show interface [port-number]
ras> show ip
Out-of-band Management IP Address = 192.168.0.1
VPS00, Device Type: Ethernet, Idle/Timeout: disable
Number of Interface : 1
enif0 : IP[192.168.0.1], Netmask[255.255.255.0], VID[0]
VPS01, Device Type: Switch, Idle/Timeout: disable, [MGMT VPS], [CNTL VPS]
Number of Interface : 2
cmif0 : IP[127.0.0.1], Netmask[255.0.0.0], VID[1]
swif2 : IP[192.168.1.1], Netmask[255.255.255.0], VID[1]
ras>
ras# show logging
0 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
7 Thu Jan 1 01:06:26 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
10 Thu Jan 1 01:06:38 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
13 Thu Jan 1 01:06:50 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
16 Thu Jan 1 01:07:05 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
20 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
21 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
24 Thu Jan 1 00:00:07 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
25 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
30 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
31 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
32 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
Clear Error Log (y/n):