ZyXEL Communications GS-4012F, User Manual

Page: 246 / 306

GS-4012F User’s Guide
Chapter 39 Introducing the Commands 245
Use these commands to configure the IP routing domains.
39.9.6 config-vlan Commands
The following table lists the
vlan
commands in configuration mode.
Table 92 interface route-domain Commands
COMMAND DESCRIPTION
interface
route-domain
<ip-address>/
<mask-bits>
Enables a routing domain for configuration.
exit
Exits from the interface routing-domain
command mode.
ip dvmrp
Enables this function to permit VLAN groups
beyond the local switch.
igmp <v1|v2>
Enables IGMP in this routing domain.
ospf authentication-
key <k>
Enables OSPF authentication in this routing
domain.
ospf authentication-
same-aa
Sets the same OSPF authentication settings in
the routing domain as the associated area.
ospf cost <1-65535>
Sets the OSPF cost in this routing domain.
ospf message-digest-
key <k>
Sets the OSPF authentication key in this
routing domain.
rip direction
<Outgoing|In>
Sets the RIP direction in this routing domain.
vrrp authentication-
key <k>
Sets the VRRP authentication key in the
routing domain.
no ip dvmrp
Disables DVMRP in this routing domain.
ip igmp
Disables IP IGMP in this routing domain.
ip ospf
authentication-key
Disables OSPF authentication key settings in
this routing domain.
ip ospf
authentication-sama
Sets the routing domain not to use the same
OSPF authentication settings as the area.
ip ospf cost
Disables the OSPF cost in the routing domain.
ip ospf message-
digest-key
Sets the routing domain not to use a security
key in OSPF.
ip vrrp
authentication-key
Resets the VRRP authentication settings.
Table 93 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
vlan <1-4094>
Creates a new VLAN group.
exit
Leaves the VLAN configuration mode.