ZyXEL Communications GS-2724, User Manual

Page: 291 / 348

Chapter 42 IEEE 802.1Q Tagged VLAN Commands
GS-2724 User’s Guide
291
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800
milliseconds and the Leave All Timer to 11000 milliseconds.
42.2.3 GVRP Timer
Syntax:
show vlan1q gvrp
This command shows the Switch’s GVRP settings.
An example is shown next.
42.2.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the Switch.
42.2.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the Switch does not propagate VLAN information to
other switches.
42.3 Port VLAN Commands
You must configure the Switch’s port VLAN settings in config-interface mode.
42.3.1 Set Port VID
Syntax:
pvid <VID>
where
This command sets the default VLAN ID on the port(s).
sysname (config)# garp join 300 leave 800 leaveall 11000
sysname# show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
sysname #
<VID>
= Specifies the VLAN number between 1 and 4094.