ZyXEL Communications GS-2724, User Manual

Page: 285 / 348

Chapter 41 Interface Commands
GS-2724 User’s Guide
285
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the ports.
• Enable tagged frame-types on the interface.
41.2.9 weight
Syntax:
weight <wt1> <wt2> ... <wt8>
where
An example is shown next.
• Enable WRR queuing on ports 2 and 6 to 8.
• Enable port 2 and ports 6 to 8 for configuration.
• Set the queue weights from Q0 to Q7.
41.2.10 egress set
Syntax:
egress set <port-list>
where
An example is shown next.
• Enable port-based VLAN tagging on the Switch.
• Enable ports one, three, four and five for configuration.
<all|tagged|
untagged>
= Choose to accept both tagged and untagged incoming frames, just
tagged incoming frames or just untagged incoming frames on a port.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
sysname(config-interface)# frame-type tagged
<wt1> <wt2> ...
<wt8>
= Sets the interface WFQ weighting. A weight value of one to eight is
given to each variable from
wt 1
to
wt 8
.
sysname# configure
sysname(config)# interface port-channel 2,6-8
sysname(config-interface)# wrr
sysname(config-interface)# weight 8 7 6 5 4 3 2 1
<port-list>
= Sets the outgoing traffic port list for a port-based VLAN.