ZyXEL Communications G-220 v3, User Manual

Page: 75 / 125

ZyXEL G-220 v3 User’s Guide
Chapter 5 Access Point Mode Configuration 75
C
H A P T E R
5
Access Point Mode
Configuration
This chapter shows you how to configure your G-220 v3 in access point mode.
5.1 Access Point Mode Introduction
To set your G-220 v3 as an Access Point (AP), select AP Mode in any utility screen (refer to
Section 1.2.4 on page 25) .
In access point mode, your G-220 v3 functions as an access point. This allows you to set up
your wireless networks without using a dedicated AP.
Note: At the time of writing this function is not available on Windows Vista.
5.1.1 ZyXEL Utility Screen Summary
This section describes the ZyXEL utility screens when the G-220 v3 is in AP mode.
Figure 47 ZyXEL Utility Menu Summary: AP Mode
The following table describes the menus.
Table 15 ZyXEL Utility Menu Summary: AP Mode
TAB DESCRIPTION
AP Mode
Link Info Use this screen to see your current connection status, configuration and data rate
statistics.
Configuration Use this screen to configure wireless LAN settings.
MAC Filter Use this screen to configure which computer(s) you want access to the wireless
LAN through the G-220 v3.