ZyXEL Communications G-2000 Plus V2, User Manual

Page: 131 / 440

ZyXEL G-2000 Plus v2 User’s Guide
Chapter 9 Static Route Screens 131
9.2.1 Configuring Route Entry
Select a static route index number and click Edit . The screen shown next appears. Fill in the
required information for each static route.
Figure 49 Static Route: Edit
The following table describes the labels in this screen.
Table 45 Static Route
LABEL DESCRIPTION
# Number of an individual static route.
Name Name that describes or identifies this route.
Active This field shows whether this static route is active ( Yes ) or not ( No ).
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is an immediate neighbor of
your ZyXEL device that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your ZyXEL device; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Edit Select a static route index number and then click Edit to set up a static route on the
ZyXEL device.
Delete To remove a static route on the ZyXEL device, click the radio button next to the
static route index number you want to remove, then click Delete .