Chapter 4 LAN
FMG Series User’s Guide
24
4.2 The Setup LAN Interface Screen
Use this screen to set the Local Area Network IP address and subnet mask of your FMG. Click
LAN > Setup
LAN Interface
to open the
Setup LAN Interface
screen.
Follow these steps to configure your LAN settings.
1
Enter an IP address into the
IP Address
field. The IP address must be in dotted decimal notation. This will
become the IP address of your FMG.
2
Enter the IP subnet mask into the
Subnet Mask
field. Unless instructed otherwise it is best to leave this
alone, the configurator will automatically compute a subnet mask based upon the IP address you
entered.
3
Click
Apply Changes
to save your settings.
If the FMG has a WAN IP address, this screen won’t be configurable.
Figure 13
LAN > Setup LAN Interface
The following table describes the fields in this screen.
Table 10 LAN > Setup LAN Interface
LABEL
DESCRIPTION
LAN Interface Settings
IP Address
Enter the LAN IPv4 IP address you want to assign to your FMG in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Subnet Mask
Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your FMG automatically computes the subnet mask based on the IP address
you enter, so do not change this field unless you are instructed to do so.
Apply Changes
Click
Apply Changes
to save your changes.
Summary of Contents for FMG Series
Page 8: ...8 PART I User s Guide...
Page 19: ...19 PART II Technical Reference...
