ZyXEL Communications ES-2024A, User Manual

Page: 177 / 221

ES-2024A User’s Guide
176 Chapter 28 Command Examples
Figure 116 wrr Command Example
28.10 interface Commands
These are some commonly used commands that belong to the
interface
group of
commands.
28.10.1 interface port-channel
Syntax:
interface port-channel <port-list>
Use this command to enable the specified ports for configuration. Type multiple ports or port
ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
• Enter the configuration mode.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.
Figure 117 interface Command Example
28.10.2 bmstorm-limit
Syntax:
bmstorm-limit
bmstorm-limit <Kbps>
where
ras# configure
ras(config)# wrr
ras(config)# wrr 4 3 2 1
ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#
Enables broadcast storm control limit on the switch.
<Kbps>
Limits broadcast packet traffic the interface receives per second.