ZyXEL Communications Dimension ES-4124, User Manual

Page: 264 / 372

ES-4124 User’s Guide
262 Chapter 42 Introducing Commands
Syntax:
logins username <username> password <password>
logins username <username> privilege <0-14>
where
42.7 Command Modes
There are three command modes: User , Enable and Configure . The modes (and commands)
available to you depend on what level of privilege your account has. See Section 42.6 on page
261 for more information on setting up privilege levels.
When you first log into the command interpreter with a read-only account (having a privilege
of 0 to 12), the initial mode is the User mode. The User mode commands are a subset of
Enable mode commands. The User mode command prompt ends with an angle bracket (>).
To enter Enable mode, type
enable
and enter the administrator password when prompted (the
default is 1234). When you enter Enable mode, the command prompt changes to the pound
sign (
#
). If you log into the command interpreter as an administrator you automatically enter
Enable mode.
The following table describes command interpreter modes and how to access them.
username <username>
= Specifies a new user (up to 32 alphanumeric characters). Enter
a user name to change the settings of an existing account.
password <password>
= Specifies the new password (up to 32 alphanumeric
characters) for this user.
privilege <0-14>
= Assigns a privilege level for the user.
Table 104 Command Interpreter Mode Summary
MODE
.
DESCRIPTION
HOW TO LOGIN/
ACCESS
PROMPT
User Commands available in this mode are
a subset of enable mode. You can
perform basic tests and display
general system information.
Default login level for a
read-only account.
sysname>
The first part of the prompt is
the system name. In the CLI
examples in this User’s
Guide, the system name is
always “sysname”.
Enable Commands available in this mode
allow you to save configuration
settings, reset configuration settings
as well as display further system
information. This mode also contains
the configure command which
takes you to config mode.
Default login level for
accounts with a
privilege of 13 or 14.
Read-only accounts
(with a privilege of 0-
12) need to type the
enable
command
and enter enable mode
password.
sysname#