ZyXEL Communications Dimension ES-3148, User Manual, Page: 231 / 282

Dimension ES-3148 User’s Guide
Chapter 32 Command Examples 229
Figure 119 ping Command Example
32.4 traceroute
Syntax:
traceroute <ip|host-name> [in-band|out-of-band|vlan <vlan-
id>][ttl <1-255>] [wait <1-60>] [queries <1-10>]
where
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100
.
Figure 120 traceroute Command Example
32.5 Enabling RSTP
To enable RSTP on a port. Enter
spanning-tree
followed by the port number and press
[ENTER]
.
An example is shown next.
ras# ping 192.168.1.100
sent rcvd rate rtt avg mdev max min reply from
1 1 100 0 0 0 0 0 192.168.1.100
2 2 100 0 0 0 0 0 192.168.1.100
3 3 100 0 0 0 0 0 192.168.1.100
ras#
<ip|host-name> =
The IP address or host name of an Ethernet device.
[in-band|out-of-
band|vlan <vlan-
id> ] =
Specifies the network interface or the VLAN ID to which the
Ethernet device belongs.
[ttl <1-255>] =
Specifies the Time To Live (TTL) period.
[wait <1-60>] =
Specifies the time period to wait.
[quesries <1-10>] =
Specifies how many tries the switch performs the traceroute
function.
ras> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
ras>