ZyXEL Communications Dimension ES-3148, User Manual, Page: 204 / 282

Dimension ES-3148 User’s Guide
202 Chapter 31 Introducing the Commands
To enter Enable (or privileged) mode, type
enable
and enter a password when prompted (the
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign (
#
).
To enter the configuration mode, type
configure
or
config
. The Configure mode command
prompt consists of the word “
config
” and the pound sign (
#
). There are various sub
configuration modes: interface, MVR and VLAN.
• To enter config-vlan mode, type
vlan
followed by a number (between 1 to 4094). For
example,
vlan 10
to configure settings for VLAN 10.
• To enter config-interface mode and configure the ports, enter
interface port-
channel
followed by a port number. For example,
interface port-channel 10
.
• To enter MVR mode, enter
mvr
followed by a VLAN ID (between 1 and 4094). For
example, enter
mvr 2
to configure multicast settings on VLAN
2
.
Enter
exit
or
logout
to quit from the current mode or log out from the CLI.
31.7 Using Command History
The switch keeps a list of up to 256 commands(s) you have entered for the current CLI
session. You can use any commands in the history again by pressing the up (
y
) or down (
z
)
arrow key to scroll through the previously used commands and press
[ENTER]
. Use the history
command to display the list of commands.
Figure 112 CLI: History Command Example
31.8 Saving Your Configuration
After you set the switch settings with the configuration commands, use the
write memory
command to save the changes permanently.
ras> history
enable
exit
show ip
history
ras>