Chapter 10 Quality of Service (QoS)
EX5501-B0 / AX7501-B0 / PX7501-B0 User’s Guide
163
10.6.1 Add/Edit a QoS Shaper
Click
Add
New Shaper
in the
Shaper Setup
screen or the
Edit
icon next to a shaper to show the following
screen.
Figure 96
Shaper Setup: Add/Edit
The following table describes the labels in this screen.
10.7 QoS Policer Setup
Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic and
apply actions, such as drop, pass, or modify, to the DSCP value of matched traffic. Click
Network Setting
> QoS >
Policer Setup
. The screen appears as shown.
Figure 97
Network Setting > QoS > Policer Setup
Table 53 Shaper Setup: Add/Edit
LABEL
DESCRIPTION
Active
Click this switch to enable or disable the shaper. When the switch turns blue
, the function is
enabled. Otherwise, it is not.
Interface
Select a Zyxel Device's interface through which traffic in this shaper applies.
Rate Limit
Enter the average rate limit of traffic bursts for this shaper.
Cancel
Click
Cancel
to exit this screen without saving any changes.
OK
Click
OK
to save your changes.
