Chapter 10 Quality of Service (QoS)
EX5501-B0 / AX7501-B0 / PX7501-B0 User’s Guide
162
10.6 QoS Shaper Setup
This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic
while keeping most outgoing traffic at the average rate. Click
Network Setting > QoS >
Shaper Setup
.
The screen appears as shown.
Figure 95
Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
802.1P Mark
Select a priority level with which the Zyxel Device replaces the IEEE 802.1p priority field in the
packets.
If you select
Unchange
, the Zyxel Device keep the 802.1p priority field in the packets.
Step4: Class Routing
Forward to
Interface
Select a WAN interface through which traffic of this class will be forwarded out. If you select
Unchange
, the Zyxel Device forward traffic of this class according to the default routing table.
Step5: Outgoing Queue Selection
To Queue Index
Select a queue that applies to this class.
You should have configured a queue in the
Queue Setup
screen already.
Cancel
Click
Cancel
to exit this screen without saving any changes.
OK
Click
OK
to save your changes.
Table 51 Classification Setup: Add/Edit (continued)
LABEL
DESCRIPTION
Table 52 Network Setting > QoS > Shaper Setup
LABEL
DESCRIPTION
Add New
Shaper
Click this to create a new entry.
#
This is the index number of the entry.
Status
This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is
active. A gray bulb signifies that this shaper is not active.
Interface
This shows the name of the Zyxel Device's interface through which traffic in this shaper applies.
Rate Limit
This shows the average rate limit of traffic bursts for this shaper.
Modify
Click the
Edit
icon to edit the shaper.
Click the
Delete
icon to delete an existing shaper. Note that subsequent rules move up by one
when you take this action.
