ZyXEL Communications AMG1202-T10A, User Manual, Page: 162 / 296

Chapter 14 Quality of Service (QoS)
AMG1202-T10A User’s Guide
162
Active Use this field to enable or disable the rule.
Application Select an application from the drop-down list box. The Destination Port Range
and Protocol ID fields may change depending on the type of applications you
choose.
Physical Ports Select Enet1 to apply the rule to the Ethernet port.
Destination MAC Type a destination MAC address here. QoS is then applied to traffic containing this
destination MAC address. Leave it blank to apply the rule to all MAC addresses.
IP Enter a destination IP address in dotted decimal notation. QoS is then applied to
traffic containing this destination IP address. A blank destination IP address
means any destination IP address.
Mask Enter a destination subnet mask here.
Port Range Either use the default value set by the application you choose, or enter the port
number to which the rule should be applied.
Source MAC Type a source MAC address here. QoS is then applied to traffic containing this
source MAC address. Leave it blank to apply the rule to all MAC addresses.
IP Enter a source IP address in dotted decimal notation. QoS is then applied to traffic
containing this source IP address. A blank source IP address means any source IP
address.
Mask Enter a source subnet mask here.
Port Range Enter the port number to which the rule should be applied. 0 means any source
port number. See
Appendix E on page 279 for some common services and port
numbers.
Protocol ID Select an IP protocol type from the drop-down list box.
Vlan ID Range Enter the source VLAN ID in this field.
IPP/DS Field Select IPP/TOS to specify an IP precedence range and type of services.
Select DSCP to specify a DiffServ Code Point (DSCP) range.
IP Precedence
Range Enter a range from 0 to 7 for IP precedence. Zero is the lowest priority and seven
is the highest.
Type of Service Select a type of service from the drop-down list box.
Available options are: Normal service , Minimize delay , Maximize
throughput , Maximize reliability and Minimize monetary cost .
DSCP Range Specify a DSCP number between 0 and 63 in this field.
802.1p Select a priority level (0 to 7) from the drop-down list box.
Action
IPP/DS Field Select IPP/TOS to specify an IP precedence range and type of services.
Select DSCP to specify a DiffServ Code Point (DSCP) range.
IP Precedence
Remarking Enter a range from 0 to 7 to re-assign IP precedence to matched traffic. Zero is
the lowest priority and seven is the highest.
Type of Service
Remarking Select a type of service to re-assign the priority level to matched traffic.
Available options are: Normal service , Minimize delay , Maximize
throughput , Maximize reliability and Minimize monetary cost .
DSCP
Remarking Specify a DSCP number between 0 and 63 to re-assign the priority level to
matched traffic.
802.1p
Remarking Select a priority level (0 to 7) to re-assign the priority level to matched traffic.
Table 58
Advanced Setup > QoS
LABEL DESCRIPTION