ZyXEL Communications AMG1202-T series, User Manual, Page: 101 / 320

Chapter 7 Wireless LAN
AMG1302/AMG1202-TSeries User’s Guide
101
7.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your AMG1302/AMG1202-TSeries.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Section 7.10.8.3 on page 115 for more information about WPS.
Note: The AMG1302/AMG1202-TSeries applies the security settings configured in the
General screen (see Section 7.2 on page 92 ). If you want to use the WPS feature,
make sure you have set the security mode to WPA2-PSK or No Security .
Click Network Setting > Wireless > WPS . The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Add new MAC
address Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
AMG1302/AMG1202-TSeries in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the
AMG1302/AMG1202-TSeries.
Modify Click the Delete icon to delete the entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 22
Network Setting > Wireless > MAC Authentication (continued)
LABEL DESCRIPTION