ZyXEL Communications AAM1212, User Manual

Page: 241 / 288

AAM1212 User’s Guide
240 Chapter 28 Switch Commands
where
This command sets the limit for how many MAC addresses may be dynamically learned on
the specified ADSL port(s).
Note: If you also use MAC filtering on a port, it is recommended that you set the MAC
count to be equal to or greater than the number of MAC filter entries you
configure.
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on ADSL port 7.
Figure 152 MAC Count Set Command Example
28.13 Packet Filter Commands
Use the following packet filter commands to filter out specific types of packets on specific
ports.
28.13.1 Packet Filter Show Command
Syntax:
switch pktfilter show [portlist]
where
<portlist>
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
<count>
= Set the limit for how many MAC addresses that a port may
dynamically learn. For example, if you are configuring port 2
and you set this field to "5", then only five devices with
dynamically learned MAC addresses may access port 2 at any
one time. A sixth device would have to wait until one of the five
learned MAC addresses ages out.
The valid range is from “1” to “1024”.
ras> switch mac count set 7 50
[portlist]
= You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.