ZyXEL Communications AAM1212-51, User Manual

Page: 331 / 435

AAM1212-51/53 Series User’s Guide
Chapter 49 IP Commands 331
49.3.3 Route Set Command
Syntax:
ras> ip route set <dst ip>[/netmask] <gateway ip> [metric] <name>
ras> ip route set default <gateway ip> <metric>
where
This command defines a new, static IP forwarding route or edits an existing one.
49.3.4 Route Delete Command
Syntax:
ras> ip route delete <dst ip>[/netmask]
where
This command removes a static, IP forwarding route.
49.3.5 Route Show Command
Syntax:
ras> ip route show
This command displays the AAM1212’s routing table.
<dst ip> =
The destination IP address of packets that this static route is to
route.
[/netmask] =
The destination subnet mask of packets that this static route is to
route.
<gateway ip> =
The IP address of the gateway that you want to send the packets
through.
[metric] =
The metric (hop count) of this static route.
<name> =
A name to identify this static route. Up to 31 ASCII characters.
Spaces and tabs are not allowed.
default =
Use this to configure the AAM1212’s default route.
<dst ip> =
The destination IP address of packets to which this static route
applies.
[/netmask] =
The destination subnet mask of packets to which this static route
applies.