ZyXEL Communications AAM1212-51, User Manual

Page: 325 / 435

AAM1212-51/53 Series User’s Guide
Chapter 48 Packet Filter Commands 325
C
H A P T E R
48
Packet Filter Commands
This chapter describes the packet filter commands.
48.1 Packet Filter Commands
Use the following packet filter commands to filter out specific types of packets on specific
ports.
48.1.1 Packet Filter Show Command
Syntax:
ras> switch pktfilter show [portlist]
where
This command displays the packet type filter settings on the specified DSL port(s) or on all
DSL ports if no port is specified.
The following example displays the packet type filter settings for DSL ports 1 and 2. “V”
displays for the packet types that the AAM1212 is to accept on the port. “-“ displays for packet
types that the AAM1212 is to reject on the port (packet types that are not listed are accepted).
When you use PPPoE only,”#” appears for all of the packet types. With PPPoE only, the
AAM1212 rejects all packet types except for PPPoE (packet types that are not listed are also
rejected).
[portlist] =
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~10>.
Figure 193 Packet Filter Show Command Example
ras> switch pktfilter show 1~2
V: pass through, -: filter out, #:Don't care
E: Enable, D: Disable
port pppoe ip arp netbios dhcp eapol igmp | PPPoE-Only
---- ----- -- --- ------- ---- ----- ---- | ----------
1 V V V V V V V | D
2 V V V V V V V | D