Form #
CF97
Date:
4/30/07
C.N. No.
106145
Rev.
E
®
PAGE 1 OF 2
AQUASPEC FAUCETS
MODEL - Z84100 SERIES
SERVICE SINK FAUCET
TECHNICAL INFORMATION
FLOW:
2.2 GPM [8.3 L] PRESSURE COMPENSATING AERATOR *
MAXIMUM PRESSURE:
125 PSI
MAXIMUM TEMPERATURE:
180
o
F
HANDLE NUT TORQUE:
15-20 FT - LBS.
CARTRIDGE STYLE:
QUARTER TURN CERAMIC DISK
* OTHER AERATORS AVAILABLE BY REQUEST
INSTALLATION INSTRUCTIONS
1. 1/2” IP NIPPLE SHOULD PROTRUDE 1/2” - 7/8” FROM THE FINISHED WALL. ON 4” TO 8 3/8” CENTERS, PIPES SHOULD
BE SECURED TO SUPPORT THE FAUCET.
2. PLACE ESCUTCHEON (ITEM #6) OVER PIPE NIPPLE AND SCREW SUPPLY ARM (ITEM #5A) ONTO PIPE. POSITION
SUPPLIES SO THAT THE BODY CONNECTIONS END UP AT 4” CENTERS ON A HORIZONTAL PLANE.
3. SUPPLY ARMS ARE FURNISHED WITH INTEGRAL SUPPLY STOPS. TO SHUT WATER OFF, SCREW STOP IN USING 5/32”
ALLEN WRENCH. OPEN STOP NO MORE THAN 5 COMPLETE TURNS. STOP CAN UNSCREW COMPLETELY CAUSING
WATER TO SPRAY FROM STOP OPENING.
4. INSERT VALVE BODY (ITEM #4) TO SUPPLY ARMS PLACING GASKET (ITEM #5C) BETWEEN BODY AND SUPPLY ARM.
5. ASSEMBLE SPOUT TO VALVE BODY USING HARDWARE.
6. TURN WATER SUPPLY ON AND OPERATE FAUCET CHECKING FOR LEAKS.
7. IT MAY BE NECESSARY TO SHUT WATER OFF AND REMOVE CARTRIDGES TO CLEAN SUPPLY LINES. CARTRIDGES
CAN BE REMOVED BY FIRST REMOVING THE HANDLES. COLOR INDEXES CAN BE REMOVED BY INSERTING A PIN
INTO THE HOLE ON THE UNDERSIDE OF THE HANDLE. AFTER THE HANDLES HAVE BEEN REMOVED, UNSCREW
AND REMOVE THE HANDLE NUTS (ITEM #1) THEN PULL OUT THE CARTRIDGE. ZURN WILL SUPPLY HANDLE PORT
PLUGS (ZURN PART #61094001) AT YOUR REQUEST.
8. REPLACE CARTRIDGES IN BODY AND HAND TIGHTEN HANDLE NUTS. PLACE HANDLES ON THE CARTRIDGE STEM
AND LOCATE THEM AS DESIRED. TIGHTEN HANDLE NUTS.
9. REPLACE HANDLE SCREWS AND COLOR INDEX BUTTONS.
10. INSTALL AERATOR, IF REQUIRED, INTO FAUCET AND HAND TIGHTEN. IT MAY BE NECESSARY TO UNSCREW AND
CLEAN AERATOR AT START-UP.
CAUTION
-
FOR INSTALLATIONS WITH ATMOSPHERIC VAUUM BREAKERS (AVB’S)
.
THIS DEVICE SHOULD NEVER
BE USED IN INSTALLATIONS THAT ARE UNDER CONTINUOUS PRESSURE WHEN INSTALLED WITH SPOUTS HAVING
ATMOSPHERIC VACUUM BREAKERS (AVB’S). THEREFORE, NEVER PLACE A SELF-CLOSING, SHUT-OFF OR CHECK VALVE
DOWNSTREAM OF AN AVB.
