Zünd S3 M-1200, Operating Manual

Page: 74 / 214

Controls and operation
74
4.4.2 Selection
A
Use the navigation keys to select an entry from the list.
B Confirm the selection with
OK
and cancel by pressing
ESC
.
4.4.3 Select commands, functions
Mark the required command with the navigation keys and select with .
The command can also be activated directly via the menu number. In order to do this, enter the
menu number using the numeric keypad (see
Direct selection of menus
on page 74).
Important:
Commands are carried out immediately after entry. An exception to this rule are safety-relevant
commands (e.g., automatic startup). Confirm the selection with OK or cancel with ESC .
4.4.4 Direct selection of menus
Each menu and each function is allocated a unique menu number. It is possible to switch between
menus by entering the menu number.
Two-figure menu numbers (10, 11...) are displayed lower down. Before entering two-digit menu
numbers, press the key and then enter both digits.
4.4.5 Function keys
The cutter has function keys (F1 - F8) which can be freely allocated to menu functions.
Allocate function keys directly
To change the function keys, at least the User level on page 76 "Operator" is required.