Zünd S3 M-1200, Operating Manual

Page: 117 / 214

Controls and operation
117
4.16.2 Initialization process
Caution:
Risk of injury during tool initialization!
The front light barriers are not active during manual initialization!
• Do not touch the operating area of the tool during initialization.
• Define the zero point with the AKI.
1-1-1-2-2 Auto init
Using AKI, the tip of the tool insert is
set exactly to the height of the working
surface (cutting/routing base). This value
serves as a starting point for setting the
up position and the down position .
1-1-1-2-3 Up Z pos
The up position defines the distance
between the zero point and the raised
tool. Select this value according to the
material and its folding properties. A short
distance between processing material
and raised tool generally means a shorter
processing time.
1-1-1-2-4 Down Z pos
The down position defines the cutting
depth of the tool into the cutting/routing
base. This is necessary in order to cut
completely through the processing
material. Down position is dependent
on the processing material and the
processing method.
1-1-1-2-5 Test cut Always perform the test cut with the
processing material and the processing
parameters of the original job. If the