Issue date
：
2020/3/16
－
16
－
5. Maintenance
5.1Replacing the consumable parts
5.1.1Replacing the LED
Please contact the after-sales service department.
5.1.2 Replacing the fuse
The fuse is integrated with main power input socket.
Please replace the fuse according to the following steps:
● Turn off the main power switch.
● Pull out the power plug from the main power plug [6].
● Find the fuse socket on the right side of power plug [6], take out the fuse socket
from the side with a small screwdriver.
● Take out the melted fuse.
● Insert a new fuse and insert the fuse socket back again.
● Plug in power cable.
● Turn on the main power switch.
Specification of fuse
：
T1.25 A/H250 V for 220VAC
T2.5 A/H250 V for 110VAC
Caution
：
Please use the bulb specially designed for this equipment.
5.1.3 Replacing the power supply cords
Replacement the power supply cords should by the manufacturer specifies service
person.
Warning: To avoid the unacceptable risk, please use the
special cords for the equipment.
5.2 Cleaning and Sterilization
Caution: Dirt on the lens must be cleaned immediately after
the surgery. It will be hard to clean when the dirt
air-dried.
