background image

 Instruction Manual

SAFETY PRECAUTION to be read before any usage of the product:

• Never subject speaker to extremes of light, temperature, moisture or vibration.

• Batteries (Battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the 

like.

• Do not use or store this speaker in a location subject to:

a. Extreme high temperature, such as in a sun-heated car.

b. Direct sunlight.

c. High humidity or places with corrosive substances.

d. Sub-zero conditions, especially during winter.

• Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. Don’t use compressed air to remove dust.

• Clean only with a dry cloth. Be careful not to wipe it with anything abrasive.

• Don’t block any of the ventilation openings, install according to the manufacturer’s

instructions.

• Refer all servicing to qualified service personnel. Servicing is required when the

unit has been damaged in any way.

• This device should be used in conditions which allow sufficient ventilation.

• Do not cover with newspaper, table clothes, curtains, etc.

• Keep minimum distances (recommended distance : 10 cm) around the apparatus

for sufficient ventilation.

• Do not place on or close to this device: flames or fire sources, such as lighted

candles, etc.

• The apparatus shall not be exposed to dripping or splashing. Objects filled with liquids, such as vases, shall be 

placed on the apparatus.

• This apparatus includes a battery. Please comply to the local regulations for

battery disposal.

• Do not use this product in extreme weather conditions.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to 

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 

radio communications. However, there is no guarantee that interference will not occur in a particular 

installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more 

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This equipment may not cause harmful interference.

2. This equipment must accept any interference received, including interference that may cause undesired 

operation.

Modifications not authorized by the manufacturer may void the user’s authority to operate this device.

LIITHIUM- ION BATTERY WARNINGS

This device contains a Lithium-ion battery. The battery must be recycled or disposed of properly. Contact 

your local waste management office for information on battery recycling or disposal.

The battery of this device can only be replaced by qualified service personnel.

Danger of explosion if battery is incorrectly replaced. Replace only with the same

or equivalent type.

Specifications:

Bluetooth version: V4.1  Support:HSP / HFP / A2DP /AVRCP

Range Class 2, up to 16.4 ft (5m)

Frequency range

2402-2480MHz

Operating Temperature

-10

~40

Power Input 5V 1A

Rechargeable Battery: 200mAh

Charging time: 2.5hours

Battery Life Approx.: up to 4 hours

Total Power Output 2Wx 2

Frequency Response :40Hz ~20kHz

Water Resistance Splash Resistant 

 IPX4

Product Weight: 75 g (approximately)

Product Dimensions

 1.83"W x 0.75"T x 25.68"L

Know you speaker

How to wear your speakers:

1)  Put the speakers on your shoulder and the wire of the speaker around your neck as shown below.

2)   Slide the magnet under the speaker and place the magnet under your t-shirt, then attach the speaker on 

your shirt. Note: thickness of your t-shirt should not be over 5 mm. 

You can adjust the speakers to their most comfortable position by moving the cable clip up or down.

Note: please make sure you remove the magnet under your shirt before you adjust the position of the 

speaker.

Charging the speakers:

1) Connect the small end of the micro USB charging cord into the battery recharge female connector of 

speaker.

2) Connect the other end of the micro USB cable to one of your computer USB port or any appropriate USB 

charger.

3) The Red LED will light up when charging.

4) LED turn in to blue when fully charged.

Note: 

1.Make sure you fully charge your speaker for 2.5 hours before using it for the first time.

2. The Speaker will be automatically off when charging.

Switch On/Off:

To switch on: When the speaker is OFF, press MFB button and hold for 2 seconds

blue LED stays on for 2 

seconds.

To switch off: When the speaker is ON, press MFB button and hold for 5 seconds, red LED light stays on for 2 

seconds.

Pairing with a Bluetooth enabled device:

First Time Pairing:

1) When the speaker is off, press MFB button for 6 seconds till you hear second set of tones and the LED will 

flash Blue and Red alternatively.

2) Keep your speaker and device within 3 feet of each other.

3) Turn on the Bluetooth function on your device and search for “Zulu Audio” in the list of available devices, and 

press connect.

4) You will hear a tone alert and the LED light will flash blue quickly after pairing connection succeeds.

Pairing with device which has been paired before.

When the speaker is off, press MFB button for 2 seconds until you hear a tone alert, it will be connected 

automatically when the Bluetooth of the device is ON. If they don’t connect in 48 seconds, the speaker will 

enter pairing mode; then follow above steps to connect the speaker to your device. (pairing memory goes up 

to 8 devices).

To clear pair list, press the vol – and vol + buttons together for 2 seconds. After this operation, the speaker will 

power off and the pair list will be cleared.

The speaker will automatically turn off after disconnect for 2 minutes.

Magnetic Field:

Can be harmful to individuals with pacemakers or similar implanted devices.

Keep away from credit cards, computer drives and recorded media.

WARNING

Do not expose speaker to dripping or splashing while charging. Speaker should not be used when 

raining or snowing. Submerging it in water or other liquids may result in permanent damage to 

speaker.

What is in the Box

Micro USB Charging Cable x 1

Carry Case x 1

Instruction Manual x 1

Wearable Speaker (with magnets) x 1

Extra magnet x 1

Cable Tie (on the speaker) x 1

(MFB button)

cable tie

Two pcs magnets 

attached with speakers

Carry case

Inside with 

1pc extra magnet

Micro USB charging cable

Reviews: