Zultys ZIP4x4, User Manual

Page: 57 / 194

6. Interacting with the Phone
47
“To enter calculator mode, press Calc”
This saves writing:
“To enter calculator mode, press Func then Mem | Calc”
6.2.1.3 Volume Keys
The volume keys are identified by the double arrows on the wide button. You press the up arrow
to increase the volume and the down arrow to decrease the volume. The keys are used for other
functions depending on the mode.
When you change the volume, the phone remembers the value you set and uses it in the future.
When you power down the phone and restore power, the phone retains the same setting. There
are five individual volume settings:
1. When the phone is idle, the volume keys control the volume of the ringer. When you press
the keys, the phone plays the ringer tone that you have currently selected. You can adjust
the volume to suit your needs. After you stop pressing the key, the ZIP4x4 continues to play
the ringer tone for two seconds.
1
2. When you are using the handset, the volume keys control the volume at which you hear the
speech from the other party through the earpiece.
3. When you are using the headset as shown in figure 4-3 on page 25, the volume keys control
the volume at which you hear the speech from the other party through the earpiece.
4. When you are using the headset as shown in section 4-4 on page 25, the volume keys control
the volume at which you hear the speech from the other party through the earpiece.
5. When you are using the speaker, the volume keys control the volume at which you hear the
speech from the other party through the speaker.
When you adjust the volume of the headset, ensure that you have the handset on the cradle. The
phone adjusts the level for the correct external headset (through a switch box or through an audio
connector) depending if you have plugged a headset into the audio connector or not.
Each volume control has twenty one settings, numbered 0 to 20. When you adjust the level, the
display shows:
The bar at the bottom of the display represents the volume graphically, from 0 to 20. When the
volume is at 0, the sound is completely turned off.
The volume control does not alter the level of the sound at which that the phone sends its signal
to the network.
1. Section 9.6.6 on page 143 describes how you select the tone that is played when the phone rings.
Volume:
Speaker 7
••••••••••••••