Zultys ZIP4x4, User Manual

Page: 149 / 194

9. The Menu
139
Proxy Password. The proxy password authenticates the ZIP4x4 to proxy servers that require
authentication. Default value is blank.
9.6.4 VLAN
You configure VLANs on the switch that is built into the phone to match your network, optimize
performance, and obtain the best speech quality. You must enter the password prior to modifying
the VLAN configuration.
You can have one to eight VLANs on the ZIP4x4. These are referred to as A, B, C, D, E, F, G, and
H. For each VLAN, you can specify the VLAN ID from 0 to 4094.
1
Each Ethernet circuit can be on different VLANs. The phone itself is considered to connect to a
separate Ethernet circuit on the switch, as shown in figure 1-3 on page 4.
To configure the VLANs, do the following:
1. If you have not already done so, enter the password as described in section 9.6.1 on page 132
so that you have rights to make the changes.
2. Select VLAN from the menu (Menu | Protected Settings | VLAN).
The display shows:
Select On to enable VLAN support within the ZIP4x4.
3. Press the enter button. The display shows:
Type a number from 0 to 4094. Use the left and right keys to edit the number as described in
section 8.2.7 on page 78. The default value is 1.
4. Press the Down button or the Enter button. The phone changes the display to:
Type a number from 0 to 4094 or press *. When you press * the phone clears the number and
indicates that this VLAN definition is not used. This is the default value.
PSettings | SIP
Proxy password
}
1. You should not normally use VLAN ID of 0. You may not obtain the results you expect if you do so.
VLAN support
}Off On
VLAN definition
A: 1
(0 to 4094)
VLAN definition
B: * not used *
(0 to 4094; * = no)