32 / 138
Identification: MD-AL-GI-00
Rev. 1.1 of 15/03/2021 - Application: GID
User’s Manual 3PH 50000TL-60000TL-V1
Rev. 1.1 15/03/2021
To prevent damage and personal injury, hold the inverter firmly when moving, as
it is a heavy piece of equipment.
Do not position the inverter with the input/output terminals in contact with
other surfaces, as these are not designed to support the weight of the inverter.
Always position the inverter horizontally.
When placing the inverter on the floor, make sure to place a support under the
unit to protect its front door.
Attention
3.6.
Installing the 3PH 50000TL-60000TL-V1 inverter
1)
Correctly position the mounting bracket on the wall using a level to ensure that it is straight; mark the
eight holes using a suitable marker pen. Keeping the hammer drill perpendicular to the wall and
avoiding any sudden movements when drilling, drill the 8 holes at the points marked on the wall using
an 8 mm drill bit. In case of errors during drilling, it is necessary to reposition the holes.
2)
Insert the plugs horizontally into the holes made, paying attention to the force and depth with which
they are inserted (make sure the plug completely enters the hole).
3)
Align the mounting bracket with the position of the holes and fix it to the wall using the most suitable
screws and flat washers, tightening them properly.
4)
Place the back hook of the inverter on the mounting bracket
5)
Secure the inverter to the mounting bracket with the M6 bolt to ensure stability.
6)
(OPTIONAL) Depending on the customer’s requirements, the inverter can be locked to the mounting
bracket with a safety lock (not supplied with the kit).
