Zte ZXR10 5250 Series, Command Reference Manual

Page: 589 / 708

Chapter 4 Service Configuration
Syntax
set loopdetect extend trunk
< trunklist >{
enable
|
disable
}
Parameter Description
Parameter Description
< trunklist > Trunk port list.
enable
Trunk ports can perform cross-device loopback detection.
disable
Trunk ports cannot perform cross-device loopback detection.
Default
Trunk ports cannot perform cross-device loopback detection.
4.35.11 show loopdetect
Purpose
This command shows loop detection information.
Command Mode
Global configuration mode
Syntax
show loopdetect
Examples
The following example shows loop detection status of all ports or trunks.
zte(cfg)#show loopdetect
The block-delay of loopdetect : 1 (min)
The packet interval of loopdetect : 5 (sec)
PortId isUp isStp isProtect isExtend loopVlanNum loopType
------ ---- ----- --------- -------- ----------- ---------
10 Down No Yes No 0 Vlan
14 Down No Yes Yes 0 Port
T1 Down No Yes No 0 Port
The displayed information is described as follows:
l
portId: port ID or trunk ID.
l
isUp: Down or Up.
l isStp: indicates whether the port participates in spanning tree calculation.
l
isProtect: indicates whether the port protection function is enabled.
l isExtend: indicates whether the large-range loopback detection function is enabled.
4-531
SJ-20131111172707-003|2013-11-27 (R1.0) ZTE Proprietary and Confidential