ZXHN H268A Maintenance Management Manual(EXETEL)
To
Do this
Display the DSL link information
and DSL connection status
Select
Internet > Status > DSL
.
Display the Ethernet interface
information and connection status
Select
Internet > Status > Ethernet
.
2.
Click
Refresh
to refresh the information.
– End of Steps –
4.1.2 Configure the DSL Connection
This procedure describes how to configure a broadband connection (WAN connection) on
the network side, so that the subscribers can access the external network.
The ZXHN H268A device supports two xDSL transfer modes: ATM and PTM.
This procedure takes
ATM
for example, and configure the four modes of using this
transfer mode.
PTM
transfer
mode
configuration
process
refers
to
ATM
transfer
mode
configuration process.
Configuration Process
l
PPPoE (IPv4) configuration process
1.
Click
Create New Item
to open the page of creating new DSL connection.
2.
Enter the name of the WAN connection in
Connection Name
.
3.
Set the DSL transfer mode to be
ATM
.
4.
Configure the
VPI/VCI
.
The
VPI/VCI
provided by carriers must be set.
5.
Set the
Type
to be
Routing
.
6.
Set the
Link Type
to be
PPP
.
7.
Set the
PPPoE Transfer Type
to be
PPPoE
.
8.
Configure the
Username
and
Password
.
The username and password are provided by carriers.
9.
Set the
IP Version
to be
IPv4
.
10. Click
Apply
to apply the changes.
While
the
default
settings
to
remaining
parameters
should
perform
well
in
most
cases,
some
reconfigurations
might
be
required to get the best performance according to open the carriers.
11. Check the configuration.
The IP address getting from carries can verify that the WAN Connection based
on IPv4 was completed successfully.
l
DHCP (IPv4) configuration process
4-2
SJ-20150916162339-007|2017-02-16 (R1.0)
ZTE Proprietary and Confidential
