Do not fold your stroller when wet.
Machine wash removable seat and armrest covers using gentle cycle,
cold water, and a mild detergent. The canopy can only be spot washed.
Line dr y fabric parts.
Never use bleach when washing.
Do not leave your stroller in direct sunlight for extended periods of time.
Clean and lubricate all moving parts on the stroller frame and wheels
as needed. Use only a penetrating silicon based lubricant.
Regularly check for loose screws, broken parts, etc. Use only Zooper
approved replacement parts available through the service centers listed below.
Wipe off any sand, salt or other corrosive residue after each use where the stroller
may be exposed to those elements.
MAINTENANCE
IMPORTANT CARE AND SAFETY INFORMATION
B
B
C
C
D
D
WARNINGS
!
INTERNATIONAL MODEL NUMBER: BU828E/Z
IMPORTANT: READ THESE SAFETY INSTRUCTIONS CAREFULLY BEFORE USING
YOUR STROLLER AND KEEP THEM FOR FUTURE REFERENCE. THE SAFETY OF
YOUR CHILD DEPENDS ON IT.
Thank you for choosing Zooper.
UNLOCKING & OPENING THE FRAME
1
4
2
INTERNATIONAL MODEL NUMBER: BU828E/Z
User Guide
Hula BU828E/Z
8
INTERNATIONAL MODEL NUMBER: BU828E/Z
INTERNATIONAL MODEL NUMBER: BU828E/Z
6
Avoid serious injur y from falling or sliding out, always use safety harness provided.
Always engage the rear brakes when not holding onto your stroller.
Never leave your child unattended.
Never use the stroller near an open fire or exposed flame.
Never allow the stroller to be used as a toy.
Never allow more than one child at a time in the stroller.
Never hang bags or other items from the handle or on the canopy. This may
cause the stroller to become unstable.
Never use the stroller on stairs or escalators.
Do not overload the basket. Maximum load is 7 lbs. Excessive weight may cause
a hazardous unstable condition to exist.
Do not overload the canopy pocket: Maximum load is 2 lbs. Excessive weight
may create a hazardous unstable condition to exist.
Before each use, check to make sure the stroller is set up properly and that all the
wheels are properly and securely attached.
This stroller is not recommended for use with a child over 55 lbs.
This stroller is designed as a walking stroller. We do not recommend running,
roller blading, or other such activities with this stroller.
This stroller is a single stroller do not use any attachments that allow for a second
child.
It may be unsafe to use accessories other than those approved by the
manufacturer or distributor.
We recommend you choose a good floor surface. Your
Zooper has a strong metal frame that could scratch
hardwood floors or other sensitive surfaces. To open the
stroller, first lift up on the red colored frame lock located
on the left side of the stroller,(Fig. 1). Be sure the frame
lock detaches from the metal locking pin. Grasp the
handle and pull back and up so that the stroller frame
opens (Fig. 2). Step down on the foot block while pulling
back on the handle so that the frame snaps open (Fig. 3).
WARNING:
Be sure children are at a safe
distance and cannot reach moving parts whenever
opening or closing the stroller.Always make sure the
stroller has opened fully by checking to see that the
metal bars connecting the foot block to the frame are
straight and parallel to the ground.
!
REAR WHEELS
To install the rear wheels, line up each wheel block with a
rear leg tube (Fig 4). The brake levers must be facing out,
away from the stroller. Locate the spring lock buttons on
the outside of the rear leg tubes. Make sure the buttons
are coming out of the buttonholes and have not slipped
inside the tube during shipping. If you are missing a
spring lock, please contact the appropriate service
center listed at the back of these instructions for
replacement parts. Push the rear wheel block onto the
rear frame leg until it clicks onto the spring lock button.
Then repeat for the other wheel block. Check visually
that the buttons have popped out of the small holes on
the outside of the wheel assembly. Pull out on each
wheel block to make sure that it has locked into place.
SECURING INFANT CARRIER
It is possible your infant carrier will NOT be compatible
with this stroller. Therefore, for first-time installation,
evaluate according to these directions without your
child in the carrier. To install the infant carrier, first be sure
it has been removed from the car seat base. Then
remove the armrest of the stroller and insert the thin
adaptor bar just as you would the armrest (Fig. 14).
Recline the backrest about 3/4 of the way down enough
so that your carrier will fit level onto the stroller seat.
Place the carrier onto the stroller so that the mounting
notch of the infant carrier fits onto the adaptor bar,
(Fig.15), and the front of the carrier rests on the backrest.
(If the mounting notch of your carrier is too small to fit
onto the adaptor bar, then position the entire carrier
between the adaptor bar, or armrest, and the backrest.
As long as it fits level onto the seat and can be secured
as described below, then it is still compatible with the
stroller). The restraint safety strap attaches to the two
metal D shaped rings on either side of the seat belt.
Place the restraint safety strap through the provided
spaces on each side of the car seat (auto seatbelt
path), or over the top of the carrier if your model does
not have that opening. Now adjust the strap to tightly
secure the carrier to the stroller. The tighter that you set
this strap will directly affect how secure the car seat
feels in the stroller. A well-tightened strap will be easily
demonstrated by lifting the entire stroller and car seat as
one solid unit, by the bar of the car seat.
WARNING:
Do not use an infant carrier if it does
not secure to the stroller as described above. Any
infant carriers rated for weights over 20 lbs are also not
compatible with this stroller. Excessive weight may
cause a hazardous unstable condition to exist.
WARNING:
Only the following infant car seat
models are compatible with this stroller: Graco - Snugride,
Peg Perego - Viaggio, Britax - Companion.
!
!
INTERNATIONAL MODEL NUMBER: BU828E/Z
3
INTERNATIONAL MODEL NUMBER: BU828E/Z
7
!
INTERNATIONAL MODEL NUMBER: BU828E/Z
5
USING THE BRAKES
To engage the brakes, step down on each rear brake
lever located between the two whee. (Fig. 11).Always
check that the
brakes have fully engaged by pushing forward on the
stroller to make sure it stays in place. Lift the brake levers
with your foot to release the brakes.
WARNING:
Do not use stroller if the buttons do
not properly pop out and lock the rear wheels in place.
Contact the appropriate ser vice center listed at the
back of these instructions for replacement parts.
!
Fig.1
Fig.2
Fig.3
Fig.4
SCREW AND NUT
FRONT WHEEL BLOCKS
Line up each front wheel block with the front leg and push
firmly together (Fig. 5). Always check to see that the
wheels have been properly installed by pulling out on the
wheel block. It should be locked to the front leg. To
remove, push in on the looped metal retention clip
located on the underside of the wheel block, and pull the
wheel block off.
Fig.5
ARMREST
To install the armrest, pinch in and push up on the
underside of the armrest clip (Fig 6). Remove the clip
completely. Slide the armrest into the slots and reinsert
the clip. Snap the fabric crotch strap around the armrest.
To open armrest from either end, pinch in on the clips as
noted above and swing the armrest out. The entire
armrest can be removed by pulling out both clips.
WARNING:
Never pick up stroller by the armrest.
CANOPY
The canopy may also be used
as a napper canopy. Locate the zipper on the rear rib of
the canopy. When unzipped, the canopy will fall forward
over the bumper bar, completely shading baby from the
world.
The canopy attaches onto the stroller frame above each
side armrest (Fig. 7). Push firmly to install. Open the
canopy by pushing down on the plastic side canopy
braces. Be sure to snap the canopy to the sides of the
seat and backrest fabric. Retract the canopy by first
pulling up on the side braces then pushing the canopy
hood back. The canopy can be converted to allow more
air flow through the stroller.
Unzip the lower half of the canopy from the upper
half. This will leave a mesh cover that can snap to the
back of the seat. To remove the canopy, first undo the
snaps. Then press the release tabs, located on the plastic
slots, while pulling up on the canopy shafts.
WARNING:
Do not tr y to retract the canopy when
the side canopy braces are fully open or with the sun visor
extended. This may damage the canopy. Whenever
the seatback is in the fully reclined position, make sure
that the canopy snaps or mesh snaps are buttoned onto
the back and sides of the seat fabric. Do not overload the
canopy pocket: Maximum load is 2 lbs (1 kg). Excessive
weight may create a hazardous unstable condition to
exist.
!
Fig.6
ADJUSTING THE SEATBACK
To lower the backrest, lift up on the plastic lever located in
the middle of the seatback and move the seatback down
into desired position. Then release the lever to secure the
seatback (Fig. 8). To raise the backrest, push up on the
back of the seat until it clicks into the desired position.
WARNING:
Always keep your child in sight when
making these adjustments. Check the fitting of the safety
harness each time the backrest is adjusted to be sure a
snug, yet comfortable fitting is maintained.
!
SAFETY HARNESS
Zooper provides a special 5-point harness safety system
on all our strollers. Used properly,this harness will keep your
child seated and safe. To secure your child in the harness,
push buckles (A) and (B) into the buckle housing (C) until
the buckle prongs snap into position. Carefully adjust
slider (D) to fit snugly and comfortably around your child
(Fig. 9). Follow the same procedure to adjust the shoulder
straps. Always retighten the harness when your child is in a
sit up or layback position.
WARNING:
Avoid serious injur y or death from
falling or sliding out. Alwaysuse the seat belt. Never leave
your child unattended.
!
LEG REST
To lower the leg rest, push up on the lever located on the
underside of the seat (Fig.10). To raise, simply push up on
the leg rest.
WARNING:
Never allow your child to sit on the leg
rest. This may result in injur y to your child and/or damage
to your Zooper. Children should always be properly
seated with the safety harness fastened.
!
Fig.8
Fig.10
WARNING:
Always engage the both brakes
when you are not holding onto the stroller and check
that the brakes have been properly engaged as
described above. Always engage the brakes when
putting your child in, or taking your child out, of the
stroller.
!
SWIVEL WHEELS
The swivel-locking lever is located on the back of the
front wheel block where it meets the frame (Fig. 12).
Push the lever up to allow the front wheels to swivel. To
lock the wheels into a fixed position, push down on the
locking lever and move the stroller forward. The wheels
will lock automatically. The wheels should be locked in
the fixed position when walking over uneven surfaces.
FULLY ENCLOSE THE CARRIAGE
SPACE
Follow these steps to enclose the seat area whenever
the backrest is fully reclined: First remove the armrest.
Then lift leg rest fabric over and off the plastic leg rest
extenders. Zip both sides of the leg rest fabric onto the
sides to the seat fabric (Fig. 13). Zip down fully and
completely. Secure the armrest back onto the stroller.
WARNING:
Your child may slip into leg openings
and strangle. Never use the stroller with the backrest fully
reclined unless the leg rest fabric is fully and completely
zipped together to the seat fabric and the canopy is
properly snapped onto the seat and backrest.
!
Fig.11
Fig.12
Fig.13
Fig.14
Fig.15
ADJUSTABLE HANDLE
To extend the handle, press the metal button located on
the plastic tube brace just below the handle. With the
button held down, pull the handle out into the desired
Position (Fig. 16). There are two extension positions. To
lower the handle, press the metal button as above and
push the handle down.
WARNING:
Never hang bags of any kind or other
items from the handle. This may cause the stroller to
become unstable.
CLOSING THE STROLLER FOR TRAVEL
OR STORAGE
Each time, before closing your stroller, check the
following:
Your child is clear of moving parts
The rear brakes have been set
The backrest is in the full, upright position
The front wheels are secure in the locked mode
The canopy is retracted
All items have been removed from the basket
Never attempt to fold or close your Zooper with your
child inside
First release the primar y lock by lifting the foot block up
with your foot (Fig 17). Then lift up on the secondar y lock
tab, just above the foot block, to release the frame. Then
step down on the safety lock located on the right side of
the stroller(Fig 18). Push the handles forward and collapse
the stroller down into the folded position (Fig 19). Check to
be sure the red frame lock secures to the locking pin.
!
Fig.16
Fig.17
Fig.18
Fig.19
B
B
C
C
D
D
A
A
Shoulders
Straps
Fig.9
Fig.7
