Zontes ZT350T-D, Maintenance Manual

Page: 135 / 152

135 / 152
11. Disassemble the engine of the vehicle
Caution:
●The vehicle must be parked on a level and stable ground or
on a lifting platform.
●The operation can only be performed after the engine has
cooled down completely.
●Do not press the brake handle after removing the rear
brake caliper.
●Attention and sequence when removing the plastic buckle
to avoid the buckle from breaking
●Wear waterproof gloves when draining coolant to prevent it
from getting on your skin.
●The storage box of subsequent production models has been
changed. For disassembly and assembly, please refer to the
chapter "Disassembly of the storage box" in "Disassembly of
Vehicle Covers".
1. Disassemble the storage box
a. Push the whole car to a wide, flat place, lay down the
main bracket, and unlock the cushion lock.
b. Use the 4 # hexagonal socket to remove the 2 M6× 16
beside the battery, take out the battery negative electrode
rubber sleeve at the arrow, use a cross screwdriver to
remove the battery negative electrode, and then take out the
battery positive electrode rubber sleeve, use a cross
screwdriver to remove the battery positive electrode, take
out the battery positive electrode wire, and then use a cross
screwdriver to screw back the bolts on the battery.
c. Take out all the fuse boxes beside the battery
d. Take out the decorative buckle (2) on the bolt, and use
the 4 # hexagonal socket to remove the two M6 × 16 bolts (1)
fixing the storage box
。
e. Lift the glove box slightly until the ambient light
connector is exposed on the left side of the glove box, unplug
the connector and take out the entire glove box.
2. Remove the cover
a. Remove the bolt decorative buckle (2) on the bolt, and
use the 4 # hexagonal socket to remove 6 M6 × 12 bolts
⑴
;
Use 12 # socket to remove 5 M8 × 25 bolts (4); Remove one
M6 at the connection between the middle of the tail skirt and
the rear armrest with the 4 # hexagonal socket × 14 Shoulder
bolt (3); Grasp any part of the rear armrest with both hands,
lift the rear armrest up in the direction of the arrow, and
then remove the rear armrest.
b. Put down the rear right foot pedal, and use the 4 #
hexagonal socket to remove the right cover to connect one
M6 × 14 of the rear right foot pedal bracket. Shoulder bolt (3)
and 1 expansion nail,; Grasp the mark of the left cover (green
rectangle) with your hand, and pull it out alternately from the
outside to the inside in the direction of the small arrow until
all five mushroom buttons (red circle) on the left cover are
pulled out, and then remove the left cover.